The reverse sear is the usual steak method turned around. You cook the meat slowly and gently first, then give it a fast, hard sear at the end. The inside comes out the same color edge to edge, with a crust that forms in about two minutes. See also Reverse sear.
Use it for steaks, thick chops and small roasts at least 1¼ in (3 cm) thick, and ideally 1½–2 in (4–5 cm). Thin cuts don’t suit it: they reach the target temperature before the gentle phase does anything useful. Sear those the regular way, see Searing.
Why it works
- Even doneness. Low heat moves slowly in from the surface, so there’s hardly a gray band beneath the crust.
- A dry surface. The slow phase dries the outside, and a dry surface browns in seconds instead of steaming. See Browning: Maillard vs. Caramelization.
- A forgiving window. At 225°F (107°C), a steak is a few degrees from done for several minutes, not 30 seconds. You have time to answer the door.
Why the sear can be so short
Most of the sear’s job is the crust. When the middle is already at temperature, you don’t need to keep the meat on the heat for long to warm it through, so you can use the hottest heat available and get off it.
Gear
- An instant-read or leave-in probe thermometer. The method runs on temperature, not time.
- A wire rack on a sheet pan for the oven version, or a grill set up with two zones (Charcoal, Gas & the Two-Zone Fire).
- A heavy cast iron pan, or a grill with the hot side fully ripping. See Cast Iron, Seasoned & Kept.
- Tongs, paper towels, and a high-smoke-point oil such as Neutral oil.
Step by step
- Salt ahead. Salt 1–24 hours ahead, uncovered on a rack in the fridge, so the surface dries. Anything under 40 minutes leaves a wet surface; salt right before cooking instead. See Salt Timing: Brining, Dry-Brining & Seasoning.
- Heat the oven or the cool side to 225–250°F (107–120°C). On the grill, bank coals to one side or light half the burners on low, and keep the steak on the cool side with the lid closed.
- Dry the steak with paper towels and set it on the rack, with a probe in the thickest part if you have one.
- Cook gently until the center is 10–15°F (6–8°C) under your target. A 1½ in (4 cm) steak takes 35–50 minutes, a thicker one up to 1½ hours. Check from 25 minutes.
- Rest 5–10 minutes, uncovered. This isn’t the final rest; it just lets the surface dry a little more. The temperature may hold or creep up a few degrees.
- Pat dry again. Any moisture that beaded on the surface is the enemy of the crust.
- Heat the pan or the grill as hot as it goes. Cast iron over high heat for 5 minutes, till it just starts to smoke; or the hot side of a charcoal grill with a full chimney of coals.
- Sear 45–60 seconds per side in a film of oil, and 20–30 seconds on each edge. Don’t walk away.
- Butter, aromatics (optional). In the last 30 seconds, add 1 tablespoon (14 g) Unsalted butter, a crushed Garlic clove and a sprig of Thyme or Rosemary, tilt the pan and spoon the foaming butter over the top. See Baste.
- Rest briefly, 3–5 minutes, then slice against the grain. Most of the resting already happened. See Why We Rest Meat & Dough.
Pull temperatures
The sear adds a few degrees, mostly near the surface. Pull when the thermometer says:
| Finished doneness | Pull at | Finished temperature |
|---|---|---|
| Rare | 105–110°F (41–43°C) | 120–125°F (49–52°C) |
| Medium-rare | 115–120°F (46–49°C) | 130–135°F (54–57°C) |
| Medium | 125–130°F (52–54°C) | 140–145°F (60–63°C) |
| Medium-well | 135–140°F (57–60°C) | 150–155°F (66–68°C) |
The USDA minimum for whole beef cuts is 145°F (63°C) with a 3-minute rest. Rarer is a personal choice, and not for the very young, the elderly, pregnant guests or anyone with a weak immune system.
Nana's tip
Err on the low side when you pull. You can always return the steak to the oven for five minutes; you can never un-cook it.
Cast iron or grill?
| Cast iron | Grill | |
|---|---|---|
| Crust | Edge-to-edge, deep, even | Grill marks, less even |
| Flavor | Butter-basted, roasty | Smoky, fire-kissed |
| Mess | Smoke indoors; open a window | None |
| Best when | You want the best crust | The whole cook is outdoors |
Do the slow phase wherever it’s easiest, then pick. A pan wins on crust; the grill wins on flavor and keeps smoke out of the kitchen.
How it differs from searing first
Searing browns the outside first, then finishes the inside at lower heat. The result is good, but the heat has to travel through the meat after the sear, which leaves a gray band under the crust and a bigger window between rare and overdone. Searing first is faster, and fine for thin cuts. Reverse searing takes longer but is more even and gives you more time.
Common mistakes
| Problem | Why | Fix |
|---|---|---|
| No crust | Surface wet, or pan not hot enough | Pat dry twice; heat the pan until it smokes |
| Overshot the target | Pulled too late; sear adds heat | Pull at the table’s temperature |
| Gray band | Seared too long | One minute a side; stop |
| Steak takes forever | Oven too low or steak straight from the freezer | Use 250°F (120°C); thaw fully |
| Thin steak overcooked | Too thin for the method | Sear first instead |
| Burnt butter | Butter in too early | Add it in the last 30 seconds |
Variations
- Thick pork chops and lamb: the same method, finishing at 140–145°F (60–63°C).
- Small roasts: a 2 lb (900 g) tenderloin or sirloin roast: 225°F (107°C) to 10–15°F short, rest, then sear on all sides.
- Add smoke: a chunk of wood on the coals during the slow phase.
- Reverse sear with no oven: the cool side of a charcoal grill with the lid on, vents set for around 250°F.
Kosher note
Kosher beef is already salted during kashering, so go light on the salt ahead of time. Salt only the surface with a pinch, wait, and taste a bit of the cooked edge before adding more at the table. Skip the butter for meat meals, and baste with oil or Schmaltz instead.