The one thing to remember: a grill is three kinds of heat working together. Learn which one is doing the work and you can cook almost anything by choosing where to put it.
The three ways heat travels
Conduction: touching
Heat passes directly from a hot surface into whatever touches it. Grill grate, cast-iron pan, griddle plate. It is why you get dark lines where meat meets metal, and why a heavy grate that has been preheated browns better than a thin one. Conduction is fast but only reaches where the food actually touches. It is the same idea as Heat, Pans & Your Stove.
Convection: moving air
Hot air and gases circulate around the food and warm it from all sides. With the lid closed, a grill becomes an oven: air rises off the fire, circles inside the dome and returns. With the lid open, that hot air escapes and food cooks mostly from below.
This is why the lid matters so much. Closed, the cooker heats the top of the food too, evens out the temperature, and holds smoke around the meat. It’s also why indirect cooking works: the food never sees the flame, but moving hot air does the cooking.
Radiation: glowing heat
Glowing coals, gas burner plates and a broiler element give off infrared energy that travels in straight lines and heats whatever surface it hits, like the sun on your face. Radiation does the heavy lifting in a quick direct sear, and it is why a hand held over the coals feels hot even without touching anything. It drops off steeply with distance, so a few inches of rack height make a big difference.
Direct vs. indirect
| Direct heat | Indirect heat | |
|---|---|---|
| Where is the food | Right over the fire | Beside the fire, with nothing underneath |
| Main heat | Radiation and conduction | Convection (lid closed) |
| Speed | Fast, intense | Slower, gentle, even |
| Browning | Strong | Gradual; weak without a finishing sear |
| Good for | Thin steaks, burgers, sausages, kebabs, vegetable slices, flatbreads | Whole chicken, roasts, thick chops, ribs, bone-in pieces, big cuts that need hours |
| Risk | Burnt outside, raw inside; flare-ups | Pale surface; slow if the lid stays open |
Most cooks do best with a two-zone fire: coals or burners on one side only. Start things over the fire for color, then slide them over to finish. Or cook them indirectly first and sear at the end (The Reverse Sear). Building that setup is covered in Charcoal, Gas & the Two-Zone Fire.
Nana's tip
Always leave yourself a cool zone. It’s the escape hatch for flare-ups, for food that browned too fast, and for anything that needs to finish gently.
What really changes cooking time
Recipes give you time ranges because these things vary. In rough order of importance:
- Thickness. The big one. Heat has to travel to the center, and the time grows faster than the thickness: doubling the thickness takes much more than twice as long. Pounding chicken breasts or spatchcocking a bird evens things out.
- Fire temperature. Hotter is faster, but only up to the point where the outside burns before the center cooks.
- Lid open or closed. Closed holds heat in; open lets it out, especially for indirect cooks.
- Weather. Wind, cold and rain pull heat from the cooker. Expect a longer cook and more fuel on a cold, windy day.
- Fuel. A fresh, full load of charcoal burns hotter and longer than a half-spent one. A nearly empty propane tank also drops pressure.
- Bone. Bone conducts heat differently from muscle; meat next to it usually finishes a bit later. Measure away from the bone.
- Surface moisture. Wet surfaces first have to dry out. Evaporation takes heat, as in The Stall.
- Starting temperature. A little. A steak straight from the fridge takes a few minutes longer than one that has sat out for a short while; it isn’t a major factor, as explained in Grilling Myths, Tested.
Because so many of these change from one cook to the next, time is a guess and a thermometer is the answer. See Doneness & Thermometers.
Heat zones
| Zone | Grate temperature | Good for |
|---|---|---|
| High | About 450–550°F (230–290°C) | Searing steaks, burgers, thin chops, kebabs, skirt steak, fast vegetables |
| Medium | About 350–400°F (175–205°C) | Chicken parts, sausages, thicker chops, fish, corn, most vegetables, finishing after a sear |
| Low | About 250–300°F (120–150°C) | Ribs, whole birds on a slow-ish cook, roasts, pork shoulder or brisket (the lower end), gentle finishing |
For smoking large cuts, cooker temperatures usually run toward the low end of this range, and sometimes below it; see Low-and-Slow, Start to Finish.
The hand test, and why to also own a thermometer
Hold your palm about 5 inches (12 cm) above the grate. How long can you keep it there?
| You can hold for | Roughly |
|---|---|
| 2 seconds | High |
| 4–5 seconds | Medium |
| 8–10 seconds | Low |
It’s a rough check, handy when the grill has no lid gauge, and no better than that. Hands differ, wind changes how it feels, and a grill’s lid dial measures air near the top, not the grate. A grate thermometer or a good probe tells you the truth. And for the food itself, never rely on guesswork: check doneness with a thermometer, against USDA’s minimums of 145°F (63°C) for whole cuts of beef, pork and lamb, 160°F (71°C) for ground meat and 165°F (74°C) for poultry.
Why it works
Food browns when its surface is dry and hot enough, around 300°F (150°C) and higher (Browning: Maillard vs. Caramelization). The inside only needs to reach a modest temperature. Direct heat delivers the first quickly; indirect heat delivers the second without burning the first. Good grilling is deciding how much of each the food needs.
What it means at the grill
- Thin and quick: direct, high, lid open or closed as you like, and stay close.
- Thick or bone-in: indirect first, lid closed.
- Not sure: start at the cool edge and move toward the fire. It’s easier to add heat than to take it back.
- Preheat the grate for 10–15 minutes, and clean it.
- Keep the lid closed unless you’re turning, saucing or checking.