Grill time is a guess: fire, wind, thickness and the cold of the meat all change it. A good thermometer reads the one thing that matters, the temperature at the center, and it’s the single best tool you can buy for the fire.
Why not time, colour or touch
- Time depends on a fire you can’t repeat exactly.
- Colour misleads: smoked or cured meat stays pink when done (see Smoke Rings & Bark), and some brown meat is still undercooked.
- The poke test varies with the cut, the fat and your own hand.
Use a thermometer for everything except the feel tests at the bottom of this page, and even those do better with a number next to them.
Which kind to buy
| Type | What it does | Verdict |
|---|---|---|
| Instant-read digital | Reads in 2–4 seconds; poked in at the end | Buy this first. Every cook needs one |
| Leave-in probe with a cable | Stays in the meat; the display sits outside the cooker | Worth it for long cooks; many also read the air temperature |
| Wireless probe | Same, with no cable and a phone or base unit | Nice for roasts and smokers; the signal can drop in a metal cooker |
| Dial (bimetal) thermometer | Slow, wide, usually inaccurate | Skip for meat; fine as a rough oven gauge |
| Lid dial on the grill | Reads air near the lid, not the grate | Not a measure of meat or grate heat |
Buy: a fast, waterproof instant-read with a thin tip, and a two-probe leave-in for smoking: one for the meat, one for the cooker. Skip: pop-up timers, dial thermometers for meat, and anything with a thick probe that makes big holes.
Where to put it
- Centre of the thickest part.
- Away from bone, fat and the grate. Bone runs hotter, fat lies, and the grate heats the tip.
- Thin cuts (burgers, chops, fillets): go in from the side, so the tip sits in the middle, rather than from the top.
- Poultry: thickest part of the breast and the thigh, not touching bone.
- Re-check in a second spot if the first reading looks odd. Use the lowest reading you find.
- Wipe the probe after raw meat before you use it on cooked.
Calibrate it
Check it every few months, or after a drop.
- Ice water: fill a glass to the top with crushed ice, add cold water, and stir for a minute. Dip the tip, without touching the glass. It should read 32°F (0°C), give or take 1–2°F.
- Boiling water: at sea level, boiling water reads about 212°F (100°C). It reads lower at altitude, about 1°F lower for every 500 ft (150 m) up. Check where you are before you assume the thermometer is off.
If it’s off, use the adjust function if it has one; if not, note the error. A thermometer that’s off by more than 3–4°F should be replaced.
Pull temperature vs. final temperature
Meat keeps cooking after it leaves the heat; the outside’s heat moves inward. That’s carryover, and it adds roughly 5°F (3°C) to a steak and 10–15°F (6–8°C) to a big roast. So you pull the meat a little under your target, then let it rest up to the final temperature. For a thin cut, 2–3°F early is plenty. The temperature rises less on a slow, low cook.
Safe Cooking Temperatures When meat, poultry, fish and eggs are done, and doneness for steak. OpenThe doneness table
Beef and lamb steaks
| Doneness | Pull at | Final after rest | Centre looks |
|---|---|---|---|
| Rare | 115–120°F (46–49°C) | 120–125°F (49–52°C) | Cool red |
| Medium-rare | 125–130°F (52–54°C) | 130–135°F (54–57°C) | Warm red-pink |
| Medium | 135–140°F (57–60°C) | 140–145°F (60–63°C) | Pink |
| Medium-well | 145–150°F (63–66°C) | 150–155°F (66–68°C) | Slightly pink |
| Well | 155°F+ (68°C+) | 160°F+ (71°C+) | Brown throughout |
Know the USDA number
USDA’s safe minimum for whole cuts of beef, pork, lamb and veal is 145°F (63°C) with a three-minute rest. Many cooks choose rare or medium-rare for whole steaks; that’s your informed call, and not advice for pregnant, very young, elderly or immune-compromised eaters. Ground meat (160°F / 71°C) and poultry (165°F / 74°C) are not negotiable, and that includes burgers, sausage and meatballs.
Other meats
| Food | Target | Notes |
|---|---|---|
| Pork chops and roasts | 145°F (63°C), then rest 3 minutes | Juicy with a slight blush; USDA minimum |
| Chicken breast | 165°F (74°C) | Pull at 160°F (71°C) for thin cuts, as carryover finishes it |
| Chicken thighs and legs | 165°F is safe; 175–185°F (80–85°C) tastes better | Dark meat has more connective tissue, which needs the extra heat to soften |
| Ground meats | 160°F (71°C); poultry 165°F (74°C) | No exceptions |
| Fish | 145°F (63°C) | Opaque and flakes; many pull a little earlier for salmon, by choice |
| Leftovers, reheated | 165°F (74°C) |
Source for the safe minimums: USDA’s chart.
Brisket, pork shoulder and ribs: feel over number
Tough, collagen-rich cuts aren’t done at a safe temperature; they’re done when the connective tissue has melted into gelatin, and that happens slowly over a range, not at a single number.
- Probe tender: brisket and pork shoulder usually get there around 195–205°F (90–96°C). Push the probe in: it should slide in with almost no resistance, like warm butter. If it grabs, give it another 30–45 minutes and test again. Test in a few places; the flat and the point finish at different times.
- The number is a hint, the feel is the verdict. A cut can be tender at 193°F or need 207°F.
- Ribs are done when they bend: pick the rack up with tongs from one end in the middle. It should sag and the surface crack, and the meat pull back from the bone ends by a quarter inch (about 6 mm) or so. A toothpick or probe slides between the bones easily.
If the temperature stops climbing for hours, that’s normal; see The Stall.
Quick rules
- Buy an instant-read before anything else.
- Check it in ice water.
- Probe the thickest part, away from bone, fat and grate.
- Pull early, and rest. See Why We Rest Meat & Dough.
- For long cooks, probe for tenderness, not a number.